dosen't work properly- W7

Resized pratition of the HDD on my NB100 using the free ware EASEUS PARTITION MASTER, and I found then some problems occurring.

First, immedeatly after repartitioning the HDD, W7 could be booted, but after the WELCOME message is on my screen, there appeared a messege saying 'preparing your desktop' or so, and when the esktop appeared, there is nothing on desktop, except a bottom-left message saying 'invalid copy of windows' or so.

I thought it would be because some hardware information on the area that manages entire disk information, including the Installation Informations, is refreshed, and W7 refered it as invalid wardware which shoud not be the same as before exerting repartitioning.

So, at first I considered that it might work correctly if I carry out the computer repairing program from the installing DVD of W7. I tried this, and no changes occurred at all. I tried next to restore system from image back up I had made a week before, and the outcome was the same.

I must note that I noticed an unexpected proceeding occurre when executing image restoring. I used the freeware PARAGON DRIVE BACKUP for image restoring, and this softwre consumes far longer time if the destination partition is reized, especially when downsized, than when restoring to the same sized partition or enlarged one. The degree of delay is amazing 2 hours for a 10GB image file. This is realy unimaginable when compared to the time needed for ordinary restoring of this size, i.e. 10 minutes or so.

Let me get back to the topic. Next I tried repartitioning again, now to enalarge the same partition as I had downsized... The consequence was nearly what I expected, say, W7 started properly, and the desktop was restored completely, but the slight change I have got was that the font has now changed to Gothic from Meyryo before. For the time being I haven't detected the cause of this yet. And don't know wheather I write any following articles that will discuss this theme in English from now.